Format Turning Mode

This command can be added by right-clicking on the “Mode Change” heading inside “Commands” tab.

This command is automatically active every time the post processor switch to turning mode on mill-turns

In other words, this command becomes active when a milling operation ends and a turning operation starts.

It also becomes active at the start of NC programs, if the first operation is a turning operation.

The G and M codes required for switching to turning mode are defined here.

MANUSpost automatically detects the switching from milling mode to turning mode and then activates “Event Turning Mode”.

“ActionTurningMode” is included as standard in “Event Turning Mode” and “ActionTurningMode” runs Format Turning Mode. in “ActionTurningMode”.