Format Milling Mode

This command can be added by right-clicking on the “Mode Change” heading inside “Commands” tab.

This command becomes automatically active every time the post processor switchs to milling mode on mill-turns.

In other words, this command becomes active when a turning operation ends and a milling operation starts.

It also becomes active at the start of NC programs, if the first operation is a milling operation.

The G and M codes required for switching to milling mode are defined inside this command.

MANUSpost automatically detects the switching from turning mode to milling mode and then activates “Event Milling Mode”.

“ActionMillingMode” is included as standard in “Event Milling Mode” and “ActionMillingMode” runs Format Milling Mode..