Format Motion First Linear

This command can be added by right-clicking on the Linear Motion. heading inside “Commands” tab.

It is used to print the first cutting movement (G1 movement) of each operation in the appropriate format in the NC program.

With this command, a special definition can be made for the first cutting movement of each operation.

IMPORTANT NOTE: In order for this command to be active, “Format Positioning At Safe Position” should not be active at the beginning of that operation.

IMPORTANT NOTE2: “Format Motion First Linear” and “Format Motion First Rapid” can not be active at the same operation. If the first movement of the operation is in cutting mode (G1), then “Format Motion First Linear” becomes active. If the first movement is in rapid mode (G0), “Format Motion First Rapid” becomes active instead.