Event Cycle / ActionCycleMotion

It is the event activated by the drilling cycles in the APT/CL file. or, in other words, by “CYCLE/DRILL” or similar expressions.

This event includes “ActionCycleMotion” as standard. “ActionCycleMotion” runs one of the drilling cycles commands depending on the type of drilling cycle detected.

IMPORTANT NOTE: At the start of each drilling cycle (ie in the CYCLE/DRILL statement in APT/CL), Event Cycle Start. will run automatically at first for once. Later, Event Cycle. becomes active for all drilling points in the same drilling cycle (i.e. all GOTO lines coming after CYCLE/DRILL and up to CYCLE/OFF).